BlueROV2
Last updated
Last updated
The BlueROV2 is an affordable high-performance underwater vehicle that is perfect for inspections, research, and adventuring.
PX4 provides experimental support for an 8-thrust vectored configuration, known as the BlueROV2 Heavy Configuration.
BlueROV2 + BlueROV2 Heavy Configuration Retrofit Kit
The motors must be wired to the flight controller following the standard instructions supplied by BlueRobotics for this vehicle .
The vehicle will then match the configuration documented in the Airframe Reference:
MAIN1: motor 1 CCW, bow starboard horizontal, , propeller CCW
MAIN2: motor 2 CCW, bow port horizontal, propeller CCW
MAIN3: motor 3 CCW, stern starboard horizontal, propeller CW
MAIN4: motor 4 CCW, stern port horizontal, propeller CW
MAIN5: motor 5 CCW, bow starboard vertical, propeller CCW
MAIN6: motor 6 CCW, bow port vertical, propeller CW
MAIN7: motor 7 CCW, stern starboard vertical, propeller CW
MAIN8: motor 8 CCW, stern port vertical, propeller CCW
BlueROV2 does not come with PX4 installed. You will need to:
Install PX4 Firmware :::note Prior to PX4 v1.12 you will need to install the "master" version.
Set the Airframe. You will need to select the "BlueROV2 Heavy Configuration" as shown:
