Holybro PM02D (digital)
Last updated
Last updated
The Holybro PM02D digital power module provides regulated power to flight controller and power distribution board, and sends information to the autopilot about battery voltage and current supplied to the flight controller and the motors.
The power module is connected using the I2C protocol. It is designed for flight controllers based on the Pixhawk FMUv5X and FMUv6X open standard, including the Pixhawk 5X.
:::note The PM is NOT compatible with flight controllers that require an analog power module, including: Pixhawk 4, Durandal, Pix32 v5, etc. :::
Max input voltage: 36V
Rated current: 60A
Max current: 120A (<60S)
Max current sensing: 164A
Battery supported: up to 6S battery
Communication protocol: I2C
Switching regulator outputs: 5.2V and 3A max
Weight: 20g
IC Used: TI INA226
PM02D board with XT60 connectors
6pin 2.00mm pitch CLIK-Mate cable to power flight controller
Additional wiring and connection information can be found in: Holybro Pixhawk 5x Wiring Quick Start.
