Holybro PM07

The Power Management Board (PM Board) serves the purpose of a Power Module as well as a Power Distribution Board. In addition to providing regulated power to Pixhawk 4 and the ESCs, it sends information to the autopilot about battery’s voltage and current supplied to the flight controller and the motors.

:::note This module can be purchased as bundle with Pixhawk 4, but can also be used with other flight controllers. :::

PM07

Specifications

• PCB Current: total 120A outputs (MAX)

• UBEC 5v output current: 3A

• UBEC input voltage: 2~12s LiPo

• Dimensions: 68 x 50 x 8 mm

• Mounting Holes: 45 x 45 mm

• Weight: 36g

Package Contents

Package Contents

• PM07 board

• 80mm XT60 connector wire (installed)

• Electrolytic capacitor: 220uF 63V (installed)

• 2x JST GH 10P Cable

• JST GH 8P Cable

• 2x JST GH 6P Cable

Where to Buy

Pixhawk 4 Power Module (PM07)

Wiring/Connections

Wiring and connection information can be found in: Pixhawk 4 > Power.

Pixhawk 4 - Power Management Board

Further Information

Quick Start Guide (Holybro)