Holybro H-RTK-M8P

:::warning This GNSS has been discontinued, and is no longer commercially available. :::

The Holybro H-RTK M8P GNSS is an RTK GNSS module series for the mass market. This family is similar to the H-RTK M9P series but uses the smaller, lighter, and less expensive M8P u-blox RTK GNSS module (which still provides far superior position resolution than previous generations_.

There are three models of Holybro H-RTK M8P to choose from, each with different antenna design to meet different needs. Refer to the Specification and Model Comparison section for more details.

Using RTK allows PX4 to get its position with centimeter-level accuracy, which is much more accurate than can be provided by a normal GPS.

h-rtk_rover

Where to Buy

• H-RTK M8P (GPS RTK Mounts)

Configuration

RTK setup and use on PX4 via QGroundControl is largely plug and play (see RTK GPS for more information).

Wiring and Connections

All H-RTK GNSS models come with a GH 10-pin connector/cable that is compatible with Pixhawk 4.

:::note The cables/connectors may need to be modified in order to connect to other flight controller boards (see pin mapbelow). :::

Pin Map

h-rtk_rover_pinmap

Specification and Model Comparison

h-rtk_spec

GPS Accessories

GPS Accessories (Holybro Website)

h-rtk